Combi Flash 7650 Series Manual de usuario descargar pdf (Pagina 71)

Section 3 Operation

3-9

3.3 Loading a RediSep Rf Column

To load a RediSep Rf column:

WARNING

The CombiFlash Torrent has redundant safety devices to limit

pressure to less than 100 psi (689 kPa). RediSep columns

smaller than 100 g are CE certified using standard IEC61010-1

for use on the CombiFlash Torrent. RediSep columns larger

than 100 g meet Pressure Vessel Directive 97/23/EC. Teledyne

Isco strongly recommends against the use of columns rated

less than 100 psi (689 kPa).

Note

For best results, always use RediSep Rf columns. The system will

not automatically detect other columns, including non-Rf RediSep

columns. The system also limits the maximum operating pressure

to 50 psi when the column is not detected.

1. Select a RediSep Rf column. The on-line help includes a

column selection guide that can assist you in selecting a

stationary phase media and column size.

CAUTION

Pinch point. Your fingers or hands can be seriously

injured if you place them between the moving parts of

the Solid Load Cartridge Cap Mount or the Upper

Column Mount. Use care when installing solid load

cartridges or columns.

2. Raise the upper column mount until it is held by the latch.

3. Insert the column onto the lower column mount.

4. Firmly grasp the upper column mount, raise it, and then

push the latch to the left to release it.

5. Slowly lower the column mount and align it with the

column inlet. The spring-loaded mount will secure the

column in place.

6. Rotate the column

4 turn to seal the fittings.

1 2 ... 66 67 68 69 70 71 72 73 74 75 76 ... 158 159

Sin comentarios

Combi Flash 7650 Series Manual de usuario Pagina 71