Combi Flash 7650 Series Manual de usuario descargar pdf (Pagina 30)

CombiFlash Torrent® User Manual

2-10

If using the optional Waste Outlet Cap (60-5394-512 for 83B

closures, 60-5394-513 for 100 mm closures), proceed with the

following steps:

3. Place the metal plate inside the plastic cap (Figure 2-2).

The plate should be oriented so that the small tube will

extend into the carboy. The small tube should extend 5 ±0.5

cm long from nut. If the tube is missing, insert it now and

finger-tighten the nut.

Figure 2-2 Optional Waste Cap (83B cap shown)

4. The tubing is secured using metal, spring-type retainers. A

pair of conventional pliers will allow you to open the

retainer enough to slide it onto the tubing. On the larger

diameter waste tube, slide one retainer about 2 inches (5

cm) onto the tubing end.

5. Feed this tube into the top of the metal plate until the

retainer is against the top of the plate.

6. Slide a retainer onto the tubing end until it is seated

against the bottom of the metal plate.

7. Thread the cap onto the carboy.

8. The smaller diameter tube is the level sense tube. Push

this tube about 2 cm into the top fitting and finger-tighten

the nut.

Nut

Metal Plate

5 cm tube extending

into carboy

Spring-type

Retainer

Place a retainer above and

below the metal plate.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 158 159

Sin comentarios

Combi Flash 7650 Series Manual de usuario Pagina 30