
CombiFlash Torrent® User Manual
3-4
The Direct Injection Adapter is recommended when using the
Liquid Load Pump to load samples directly on the column, or
when there is a need to bypass the automated injection valve
during sample injections.
3.1.4 Liquid Injection Adapter
The Liquid Injection Adapter (60-5244-059) should be used
when performing liquid sample injections with a syringe. The
valve prevents the liquid from be forced back out of the
injection port. Refer to section 3.4.1 for more information.
3.1.5 Prime Tube Assembly
The prime tube assembly (209-0165-76), also called a column
bypass tube, can be used in place of a column when
purging/priming the system and when performing
maintenance.
3.1.6 Prime Pump Plug, 1/8-inch
Use this plug (209-0165-21) to cap the B Solvent’s Prime port
when this port is not in use.
3.1.7 Stylus
The stylus with adhesive-backed mounting plate may be
attached near the LCD display for precise control of the touch
screen.
3.1.8 Test Mix B Vials and 5 mL Syringe
Test Mix B can be used to determine if the system is operating
correctly. Refer to S
YSTEM VERIFICATION WITH TEST MIX B in
section 2.15 for instructions.
3.1.9 Cable Clips and Ties
Use the clips and ties to secure tubing or wiring after
installation.
3.2 Sample Preparation
Before starting a run, consider how the sample will be
introduced to the column media. This section discusses three
methods: liquid injection, solid sample cartridges, and
preloading the sample on the column.
Comentarios a estos manuales