Combi Flash 7650 Series Manual de usuario Pagina 26

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 159
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 25
CombiFlash Torrent® User Manual
2-6
Note
If a System Verification (Section 2.15) will be performed, the
required solvents are hexane (Solvent A) and ethyl acetate
(Solvent B).
The Torrent may receive solvent from:
User-supplied solvent containers at atmospheric
pressure
Teledyne Isco’s pressurized canisters
Pressurized or gravity-fed solvent delivery lines in the
laboratory.
Refer to the appropriate installation section (2.6.1 through
2.6.3) according to your solvent source.
2.6.1 Solvent Containers at Atmospheric Pressure
The Torrent can form a binary gradient from two solvents, A
and B. These solvents connect to the left side panel of the
Torrent (Figure 1-2). To connect the solvents:
1. Locate the Solvent A inlet line. This assembly consists of
two tubes fastened togethera solvent line and a smaller
diameter air line to measure the solvent level.
2. Connect the large fitting to the Torrent’s A INLET port:
a. Position the end with the threaded fitting near the port.
b. Rotate the fitting until the inlet line is routed the
desired direction.
c. Finger-tighten the pre-swaged fitting to the port.
d. Use a wrench to tighten the fitting an additional
1
8
turn.
3. Connect the air line to the A LEVEL port (refer to
Figure 2-1):
Figure 2-1 Level tubing connection with nut and ferrule
Tubing
Nut
60-0923-015
Ferrule
60-0083-163
Level Port
Vista de pagina 25
1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 158 159

Comentarios a estos manuales

Sin comentarios