Combi Flash 7650 Series Manual de usuario Pagina 23

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 159
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 22
Section 2 Preparation
2-3
quickly be removed from the outlet in the event of an
emergency.
CAUTION
Unless power must be removed due to an emergency, always wait
at least one minute after placing the system in Standby before
removing the AC mains power cord.
2.4 Connect Optional Interface Cables
Rear panel connections support a variety of devices. Electrical
connections to networks or optional equipment should be
completed at this time.
Review the options below and complete as necessary.
Note
Detailed information about each of these optional devices is
provided in Section 2.10 INSTALL OPTIONAL EQUIPMENT.
2.4.1 Cabling: Sample Load Pump
To connect a Sample Load Pump to the Torrent, attach the
pump’s power cable to the Torrent’s back panel connector
labeled “SAMPLE LOAD PUMP.
2.4.2 Cabling: Fractionation Valve
To connect a Fractionation Valve to the Torrent, attach the
valve’s 9-pin power/control cable to the Torrent’s back panel
connector labeled “FRACTION VALVE.”
2.4.3 Cabling: Foxy R2 High Flow Fraction Collector
The Torrent can control up to four Foxy R2 High Flow fraction
collectors via an Ethernet network.
To connect one, or the first of multiple Foxys, connect a
standard straight-through network cable between the
Ethernet ports on the Torrent and a Foxy. The second
Ethernet port on the Foxy can be used to add the next Foxy.
The Torrent can supply AC power to one Foxy. Connect one
end of the cable to the female IEC connector on the Torrent.
Connect the other end to the Foxy power connector.
Vista de pagina 22
1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 158 159

Comentarios a estos manuales

Sin comentarios