Combi Flash EX 655 Especificaciones descargar pdf (Pagina 8)

8 Translation of the original operation manual

MDFE_mAtex_1307_en • jw

Safety

2.2 Safety instructions

Observe the operating instructions for the spray device!

Material flow heaters are only used in conjunction with an

appropriate spray device depending on the design (high-pressure or

low-pressure) in high- or low-pressure processes and with appropriate

spraying accessories.

Inappropriate use can lead to severe injury.

➤ Read the operating manual of the spraying device and its accesso-

ries that are in use and follow the instructions the manual contains.

2.2.1 Operating pressure

WARNING

Unit components that do not comply with the maximum permissible oper-

ating pressure can burst and cause serious injury.

➤ The specified maximum operating pressures must generally be com-

plied with for all unit components. In case of varying operating pres-

sures, the lowest value is always the one to be taken as the maximum

operating pressure for the entire unit.

➤ Material hoses and hose assemblies must comply with the maximum

operating pressure, including the required safety factor.

➤ Material hoses must be leak tight and free of kinks, signs of abrasion

or bulges.

➤ Hose connections must be tight.

2.2.2 Power supply

WARNING

Use in an area where solvent vapours exist can cause the power cable to

become porous or cracked.

➤ Therefore, the power cable must be inspected visually for damage

before each operation.

➤ Never make repairs to the power cable. It must be replaced completely

by a qualified technician.

WARNING

➤ Before connecting the Fluid Heater to the electrical supply, check to

ensure that the point of hook-up is functioning correctly and no faults

are present.

➤ In case of power failure, disconnect the power supply to prevent the

Fluid Heater from switching on independently.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 37 38

Sin comentarios

Combi Flash EX 655 Especificaciones Pagina 8