Combi Flash EX 655 Especificaciones descargar pdf (Pagina 28)

28 Translation of the original operation manual

MDFE_mAtex_1307_en • jw

Start-up and operation

have been performed, make an optical check of the equipment for any

signs of leaks or other defects.

3. Prepare paint spray equipment

Follow the instructions for preparing the system for spraying found in the

Operation manual for the equipment.

4. Flush

Due to the possibility that solvent or solvent fumes can still be found within

the Fluid Heater and/or spray system, the coating must first be sprayed

cold for approx. one to two minutes back into the material feed container.

5. Power supply connection

Connect the Fluid Heater power supply cable to a corresponding electrical

connection.

The Fluid Heater must be rated for the available power supply (volta-

ge, amperage, wattage).

WARNING

If the

Fluid Heater is to be used in an area that falls under explo-

sion-proof regulations, ensure that an approved electrical power connection

is used.

6. Setting the temperature

Set the desired temperature on the temperature knob

(see Pic. 5.1).

The control lamp remains lit while the Fluid Heater

is heating. Once the set temperature is reached, the

lamp goes out. If the heater begins heating again, the

lamp will turn on again.

If the ambient temperature is under 10°C (50°F), the

reset button (see Pic. 5.1) must be pressed until the

control lamp turns on.

temperature

knob

Reset

Pic. 5.1

If the maximum allowable temperature is surpassed, a temperature limiter will

turn off the Fluid Heater.

To turn the Fluid Heater back on, press the reset button (see Pic. 5.1) until the

control lamp goes on again.

7. Operation

WARNING

Never place hands or fingers in or near the spray jet.

The spray system and Fluid Heater are now ready for operation.

– You can now commence with coating the desired object.

– Pay close attention to the instructions found in the operation manual

for the spraying equipment.

– If using a Hot Spray system without circulation, cold material is still

located in the hoses.

It is recommendable to pump the material back into its container until

heated material exits the spray gun.

– When using two-component materials, the potlife must be observed.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 37 38

Comentarios a estos manuales

Sin comentarios

Combi Flash EX 655 Especificaciones Pagina 28

Comentarios a estos manuales

Relacionado con productos y manuales para Cochecitos Combi Flash EX 655