Combi Flash EX Especificaciones descargar pdf (Pagina 17)

Spectrofluorophotometer Standard Operating Procedure

Model:

Serial Number:

For the Panoroma Fluorescence 2.1 software:

1) Hit the white switch to turn on the spectrofluorophotometer. Do not touch the XE lamp

switch (black). Listen for the clicking sounds. Once the instrument is on, the power

indicator lamp (front face) will light up.

2) Wait for 15 minutes.

3) Open software “Panoroma Fluorescence 2.1”.

4) Insert cuvette into sample holder (position 1).

5) Under “RF5301”tab, click on “2D emission”.

6) Set parameters.

7) Hit “measure”

After data aqusition: turn off instrument (white switch), then close software.

For the RF5301-PC software:

Turn the xenon power switch ON. Then turn ON power to the instrument. Listen for a clicking

sound. The lamp will automatically light. Verify the power display lamp on the front of the

instrument is ON.

If the xenon lamp does not light or if there is no clicking sound or if the clicking sound continues

without the xenon lamp lighting, switch power to OFF immediately.

Open software

Initialization procedure will begin. Requires about 30 seconds.

Application window will appear.

SPECTRUM SCAN

Acquire Mode—Spectrum

Configure—Parameters

Set the following:

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 49 50

Sin comentarios

Combi Flash EX Especificaciones Pagina 17