
November 2014
Marathon 65, Boulevard
65, Boulevard 65 CS,
Advocate 65 CS
connectors coming off the base of Britax infant/child car seats.
Britax has determined that a limited number of infant/child car seats were
manufactured with base joint connectors that were improperly installed. Britax
found that the performance of the car seats was not adversely affected.
Transport Canada has reviewed all the test documentation and agrees with
Britax that the problem appears to pose no safety risk and that, even with both
connectors missing, the infant/child seats, when installed properly, would
perform as intended. Transport Canada and Britax recommend that you ensure
that your infant/child car seat is properly installed using the vehicle seat belt or
UAS (Universal Anchorage System) and tether strap, as outlined in the user
guide.
Owners of affected car seats may call Britax Child Safety, Inc. at 1-888-427-
4829 to receive a kit containing replacement base joint connectors, tools and
instructions.
Chaperone:
E9K952J (BK/Silv)
E9L952K(Red)
E9L952L (Cow)
The rivet that secures the harness adjuster (A-Loc) to the seat shell may have
been incorrectly installed and could fail. If the harness adjuster detaches from
the shell, the harness system would no longer be able to properly restrain the
child increasing the chance of injury in a crash. Contact Britax at 1-888-427-
4829 to request a repair kit free of charge.
Chaperone, Models
E9L95P2, E9L95P3,
E9L95P5
April 10, 2009 – May
31, 2010
The resin used in the manufacturing process of the chest clips was incorrectly
processed which resulted in a more brittle chest clip. To identify if the chest clip
is subject to the recall, flip it over and look for a stamp stating “PC”. If such
moulding is present contact Britax at 1-888-427-4829. If the stamp on the back
of the chest clip states “POM” then the chest clip is not affected by the recall.
Frontier, E9L75M6,
E9L75H6
June 6, 2008 – Sept 17,
2008
There is potential for one side of shoulder harness to become detached from
yoke on the back of the child/booster seat when loosening harness to remove a
child. Should this happen and not be detected by the parent, the harness would
not securely restrain the child in the event of a collision. Britax has developed
rubber caps to be placed on the end of the metal harness yoke, which will
prevent the harness from detaching and will supply the rubber caps free of
charge to registered Frontier owners. Unregistered owners call 1-888-427-4829
for free rubber caps.
Jan 1/99 – Dec 15/07
inclusive
The affected units are labelled for rear-facing use by children between birth and
13.6kg (30lbs) and birth to 76 cm(30 inches). For infants below 2.3 kg (5lbs)
and 55.9cm (22) inches, the lowest harness slots may not allow a snug fit when
Comentarios a estos manuales